Polaroid SprintScan 45 Manuel d'utilisateur télécharger pdf (Page 18)

Place the scanner at the end of the chain and use the termina-

tor provided. Do not add any additional terminators. If one

external device has an internal terminator, see the previous

example. Use only approved SCSI cables.

Tu r ning on the scanner

1 With the scanner off, plug the power cord provided into the

scanner (picture 4), and then into an appropriate grounded

outlet. The scanner can operate over a voltage range from 100

to 240 VAC.

2 Turn on the scanner; the switch is next to the power

connector. The POWER indicator light on the front of the unit

will light, the cold cathode lamp will come on (visible

through the slit on the top of the unit), and the READY indica-

tor will flash briefly. The scanner will perform a self-test that

lasts for a few seconds. If no problems are detected, the

READY light will stay lit. The cold cathode lamp will also

stay on.

3 Once the ready light is lit, turn on your computer.

Setup and use 2-9

Scanner and another

unterminated device

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

Pas de commentaire

Polaroid SprintScan 45 Manuel d'utilisateur Page 18